This machine is improved on the basis of the import machine，Applicable to power and cylindrical battery cell pole piece slitt.

Equipment features:

1)  Continuous disk blade slitting , burr-free cutting,

2)   winding down by the gas-axis  tension winding up, all operations all use man-machine interface input control, is intelligent continuous slitter ;

3)   The sub-cutter-axis servo motor drive, the knife and the knife were servo motor drive, the margin cut, cut very small pieces distortion, ripple-free;

4)   The main drive servo motor control, speed and stability;

5)    has the winding tension and the tension cut out the difference between the control;

6)    with the constant value of the winding tension, small deformation;

7)   Have cut tool car；

Equipment performance indicators:

1)   mechanical speed 50m/min, 75m/min continuously adjustable;

2)   cutting width accuracy: less than 0.02 mm;

3)   the maximum cutting sheet width: less than 570mm/670mm;

4)   receive and put the scroll for the gas up the shaft , shaft diameter 76.2mm (3 inch standard type);

5)   the largest collection diameter 500mm;

6)   the volume of the volume of 150 ~ 300kg, the volume load bearing 150 ~ 300Kg;

7)   receive , automatic tension control, tension value can be set continuously, the volume synchronization control;

8)   slitter wind error: ：±0.2 mm

9)    material unwinding diameter: diameter 500mm;

10)  cutter diameter: 130mm diameter; cutting blade for hard alloy blade;

11)  the maximum cutting waste edge width: less than 5mm (max);

12)  cutting edge without burr, ripple free; after cutting, edge burr is less than or equal to 9um,